Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 1025
Brocade 6910 Ethernet Access Switch Configuration Guide
975
53-1002581-01
Connectivity Fault Management
42
Cross-check Errors
•
Cross Check MA Up – Sends a trap when all remote MEPs in an MA come up.
An MA Up trap is sent if cross-checking is enabled
19
, and a CCM is received from all remote
MEPs configured in the static list for this maintenance association
20
.
•
Cross Check MEP Missing – Sends a trap if the cross-check timer expires and no CCMs have
been received from a remote MEP configured in the static list.
A MEP Missing trap is sent if cross-checking is enabled
19
, and no CCM is received for a remote
MEP configured in the static list
20
.
•
Cross Check MEP Unknown – Sends a trap if an unconfigured MEP comes up.
A MEP Unknown trap is sent if cross-checking is enabled
19
, and a CCM is received from a
remote MEP that is not configured in the static list
20
.
Interface
To configure global settings for CFM:
1. Click Administration, CFM.
2. Select Configure Global from the Step list.
3. Before enabling CFM processing on the switch, first configure the required CFM domains,
maintenance associations, and static MEPs. Then set the delay time to wait for a remote MEP
comes up before the switch starts cross-checking the end points learned through CCMs
against those stored in the static list.
4. Adjust the parameters for the link trace cache as required.
5. Enable the required traps for continuity check and cross-check errors. Remember that the
“Connectivity Check” and “Cross Check” fields on the MA Configuration page must be enabled
before related errors can be generated.
6. Click Apply.
20. See