Network-access guest-vlan, Network-access link-detection, Network-access – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 252: Guest-vlan

Advertising
background image

202

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Network Access (MAC Address Authentication)

10

network-access guest-vlan

Use this command to assign all traffic on a port to a guest VLAN when 802.1x authentication is
rejected. Use the no form of this command to disable guest VLAN assignment.

Syntax

network-access guest-vlan vlan-id

no network-access guest-vlan

vlan-id - VLAN ID (Range: 1-4093)

Default Setting

Disabled

Command Mode

Interface Configuration

Command Usage

•

The VLAN to be used as the guest VLAN must be defined and set as active (See the

vlan

database

command).

•

When used with 802.1X authentication, the intrusion-action must be set for “guest-vlan” to be
effective (see the

dot1x intrusion-action

command).

Example

Console(config)#interface ethernet 1/1

Console(config-if)#network-access guest-vlan 25

Console(config-if)#

network-access link-detection

Use this command to enable link detection for the selected port. Use the no form of this command
to restore the default.

Syntax

[no] network-access link-detection

Default Setting

Disabled

Command Mode

Interface Configuration

Example

Console(config)#interface ethernet 1/1

Console(config-if)#network-access link-detection

Console(config-if)#

Advertising