Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 576)

526 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
CFM Commands
25
ethernet cfm ais level
This command configures the maintenance level at which Alarm Indication Signal (AIS) information
will be sent within the specified MA. Use the no form restore the default setting.
Syntax
ethernet cfm ais level level-id md domain-name ma ma-name
no ethernet cfm ais level md domain-name ma ma-name
level-id – Maintenance level at which AIS information will be sent. (Range: 0-7)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
Default Setting
Level 0
Command Mode
Global Configuration
Command Usage
The configured AIS level must be higher than the maintenance level of the domain containing the
specified MA.
Example
This example sets the maintenance level for sending AIS messages within the specified MA.
Console(config)#ethernet cfm ais level 4 md voip ma rd
Console(config)#
ethernet cfm ais ma
This command enables the MEPs within the specified MA to send frames with AIS information
following detection of defect conditions. Use the no form to disable this feature.
Syntax
[no] ethernet cfm ais md domain-name ma ma-name
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
Default Setting
Disabled
Command Mode
Global Configuration