Erps domain, Control-vlan, Erps domain control-vlan – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 411
Brocade 6910 Ethernet Access Switch Configuration Guide
361
53-1002581-01
ERPS Commands
19
Related Commands
erps domain
This command creates an ERPS ring and enters ERPS configuration mode for the specified domain.
Use the no form to delete a ring.
Syntax
[no] erps domain name
name - Name of a specific ERPS ring. (Range: 1-12 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Up to 6 ERPS rings can be configured on the switch.
Example
Console(config)#erps domain r&d
Console(config-erps)#
control-vlan
This command specifies a dedicated VLAN used for sending and receiving ERPS protocol
messages. Use the no form to remove the Control VLAN.
Syntax
[no] control-vlan vlan-id
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
•
Configure one control VLAN for each ERPS ring. First create the VLAN to be used as the control
VLAN (
), add the ring ports for the east and west interface as tagged members
to this VLAN (
), and then use the
command to
add it to the ring.