Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 665)

Brocade 6910 Ethernet Access Switch Configuration Guide 615
53-1002581-01
IPv6 Interface
29
clear ipv6 traffic
This command resets IPv6 traffic counters.
Command Mode
Privileged Exec
Command Usage
This command resets all of the counters displayed by the show ipv6 traffic command.
Example
Console#clear ipv6 traffic
Console#
ping6
This command sends (IPv6) ICMP echo request packets to another node on the network.
Syntax
ping6 {ipv6-address | host-name} [count count] [size size]
ipv6-address - The IPv6 address of a neighbor device. You can specify either a link-local or
global unicast address formatted according to RFC 2373 “IPv6 Addressing Architecture,”
using 8 colon-separated 16-bit hexadecimal values. One double colon may be used in the
address to indicate the appropriate number of zeros required to fill the undefined fields.
host-name - A host name string which can be resolved into an IPv6 address through a
domain name server.
count - Number of packets to send. (Range: 1-16)
size - Number of bytes in a packet. (Range: 48-18024 bytes)
The actual packet size will be eight bytes larger than the size specified because the router
adds header information.
Default Setting
count: 5
size: 100 bytes
UDP Statistics
input The total number of UDP datagrams delivered to UDP users.
no port errors The total number of received UDP datagrams for which there was no application at
the destination port.
other errors The number of received UDP datagrams that could not be delivered for reasons
other than the lack of an application at the destination port.
output The total number of UDP datagrams sent from this entity.
TABLE 147 show ipv6 traffic - display description (Continued)
Field Description