Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 256)

206 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Network Access (MAC Address Authentication)
10
Example
Console(config-if)#network-access mode mac-authentication
Console(config-if)#
network-access port-mac-filter
Use this command to enable the specified MAC address filter. Use the no form of this command to
disable the specified MAC address filter.
Syntax
network-access port-mac-filter filter-id
no network-access port-mac-filter
filter-id - Specifies a MAC address filter table. (Range: 1-64)
Default Setting
None
Command Mode
Interface Configuration
Command Mode
• Entries in the MAC address filter table can be configured with the network-access mac-filter
command.
• Only one filter table can be assigned to a port.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access port-mac-filter 1
Console(config-if)#
mac- authentication intrusion-action
Use this command to configure the port response to a host MAC authentication failure. Use the no
form of this command to restore the default.
Syntax
mac-authentication intrusion-action {block traffic | pass traffic}
no mac-authentication intrusion-action
Default Setting
Block Traffic
Command Mode
Interface Con figuration
Example
Console(config-if)#mac-authentication intrusion-action block-traffic
Console(config-if)#