Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 966)

916 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Link Layer Discovery Protocol
42
3. Click Apply.
FIGURE 237 Configuring SMTP Alert Messages
Link Layer Discovery Protocol
Link Layer Discovery Protocol (LLDP) is used to discover basic information about neighboring
devices on the local broadcast domain. LLDP is a Layer 2 protocol that uses periodic broadcasts to
advertise information about the sending device. Advertised information is represented in Type
Length Value (TLV) format according to the IEEE 802.1ab standard, and can include details such as
device identification, capabilities and configuration settings. LLDP also defines how to store and
maintain information gathered about the neighboring network nodes it discovers.
Setting LLDP Timing Attributes
Use the Administration > LLDP (Configure Global) page to set attributes for general functions such
as globally enabling LLDP on the switch, setting the message ageout time, and setting the
frequency for broadcasting general advertisements or reports about changes in the LLDP MIB.
CLI References
• “LLDP Commands” on page 505
Parameters
These parameters are displayed:
• LLDP – Enables LLDP globally on the switch. (Default: Enabled)
• Transmission Interval – Configures the periodic transmit interval for LLDP advertisements.
(Range: 5-32768 seconds; Default: 30 seconds)