Ipv6 acls, Access-list ipv6, Table 59 – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 296

Advertising

246

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

IPv6 ACLs

The commands in this section configure ACLs based on IPv6 addresses, DSCP traffic class, or next
header type. To configure IPv6 ACLs, first create an access list containing the required permit or
deny rules, and then bind the access list to one or more ports.

access-list ipv6

This command adds an IP access list and enters configuration mode for standard or extended IPv6
ACLs. Use the no form to remove the specified ACL.

Syntax

[no] access-list ipv6 {standard | extended} acl-name

standard – Specifies an ACL that filters packets based on the source IP address.

extended – Specifies an ACL that filters packets based on the destination IP address, and
other more specific criteria.

acl-name – Name of the ACL. (Maximum length: 32 characters)

Default Setting

None

Command Mode

Global Configuration

Command Usage

•

When you create a new ACL or enter configuration mode for an existing ACL, use the permit or
deny command to add new rules to the bottom of the list. To create an ACL, you must add at
least one rule to the list.

•

To remove a rule, use the no permit or no deny command followed by the exact text of a
previously configured rule.

•

An ACL can contain up to 64 rules.

Example

Console(config)#access-list ipv6 standard david

Console(config-std-ipv6-acl)#

TABLE 59

IPv6 ACL Commands

Command

Function

Mode