Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 802)

752 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Setting Static Addresses
35
• MAC Address – Physical address of a device mapped to this interface. Enter an address in the
form of xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
• Static Status – Sets the time to retain the specified address.
• Delete-on-reset - Assignment lasts until the switch is reset.
• Permanent - Assignment is permanent. (This is the default.)
Interface
To configure a static MAC address:
1. Click MAC Address, Static.
2. Select Add from the Action list.
3. Specify the VLAN, the port or trunk to which the address will be assigned, the MAC address,
and the time to retain this entry.
4. Click Apply.
FIGURE 105 Configuring Static MAC Addresses
To show the static addresses in MAC address table:
1. Click MAC Address, Static.
2. Select Show from the Action list.
FIGURE 106 Displaying Static MAC Addresses