Figure 262 confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 996
946
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Simple Network Management Protocol
42
•
Local User Name – The name of a local user which is used to identify the source of SNMPv3
trap messages sent from the local switch. (Range: 1-32 characters)
If an account for the specified user has not been created (
), one will be automatically
generated.
•
Remote User Name – The name of a remote user which is used to identify the source of
SNMPv3 inform messages sent from the local switch. (Range: 1-32 characters)
If an account for the specified user has not been created (
), one will be automatically
generated.
•
UDP Port – Specifies the UDP port number used by the trap manager. (Default: 162)
•
Security Level – When trap version 3 is selected, you must specify one of the following security
levels. (Default: noAuthNoPriv)
•
noAuthNoPriv – There is no authentication or encryption used in SNMP communications.
•
AuthNoPriv – SNMP communications use authentication, but the data is not encrypted.
•
AuthPriv – SNMP communications use both authentication and encryption.
Interface
To configure trap managers:
1. Click Administration, SNMP.
2. Select Configure Trap from the Step list.
3. Select Add from the Action list.
4. Fill in the required parameters based on the selected SNMP version.
5. Click Apply
FIGURE 262
Configuring Trap Managers (SNMPv1)