Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 619)

Brocade 6910 Ethernet Access Switch Configuration Guide 569
53-1002581-01
OAM Commands
26
Command Usage
• You can use this command to perform an OAM remote loopback test on the specified port. The
port that you specify to run this test must be connected to a peer OAM device capable of
entering into OAM remote loopback mode. During a remote loopback test, the remote OAM
entity loops back every frame except for OAMPDUs and pause frames.
• OAM remote loopback can be used for fault localization and link performance testing.
Statistics from both the local and remote DTE can be queried and compared at any time during
loopback testing.
• A summary of the test is displayed after it is finished.
Example
Console#efm oam remote-loopback test 1/1
Loopback test is processing, press ESC to suspend.
....
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/2 1990 1016 48.94 %
Console#
show efm oam counters interface
This command displays counters for various OAM PDU message types.
Syntax
show efm oam counters interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam counters interface 1/1
Port OAMPDU Type TX RX
---- --------------------- ---------- ----------
1/1 Information 1121 1444
1/1 Event Notification 0 0
1/1 Loopback Control 1 0
1/1 Organization Specific 76 0
Console#