Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 821)

Brocade 6910 Ethernet Access Switch Configuration Guide 771
53-1002581-01
Displaying Interface Settings for STA
36
Interface
To configure interface settings for STA:
1. Click Spanning Tree, STA.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Modify any of the required attributes.
5. Click Apply.
FIGURE 120 Configuring Interface Settings for STA
Displaying Interface Settings for STA
Use the Spanning Tree > STA (Configure Interface - Show Information) page to display the current
status of ports or trunks in the Spanning Tree.
CLI References
• “show spanning-tree” on page 356
Parameters
These parameters are displayed:
• Spanning Tree – Shows if STA has been enabled on this interface.
• BPDU Flooding – Shows if BPDUs will be flooded to other ports when spanning tree is disabled
globally on the switch or disabled on a specific port.
• STA Status – Displays current state of this port within the Spanning Tree:
• Discarding - Port receives STA configuration messages, but does not forward packets.
• Learning - Port has transmitted configuration messages for an interval set by the Forward
Delay parameter without receiving contradictory information. Port address table is cleared,
and the port begins learning addresses.