Figure 340 dis – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 1096

Advertising
background image

1046

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Displaying the Routing Table

44

The Routing Table (and

show ip route

command) only displays routes which are currently

accessible for forwarding. The router must be able to directly reach the next hop, so the VLAN
interface associated with a static route entry must be up. Note that routes currently not
accessible for forwarding, may still be displayed by using the

show ip route database

command.

Parameters

These parameters are displayed in the web interface:

VLAN – VLAN identifier (i.e., configured as a valid IP subnet).

Destination IP Address – IP address of the destination network, subnetwork, or host.
Note that the address 0.0.0.0 indicates the default gateway for this router.

Net Mask – Network mask for the associated IP subnet. This mask identifies the host address
bits used for routing to specific subnets.

Next Hop – The IP address of the next hop (or gateway) in this route.

Metric – Cost for this interface. (Not applicable for current phase.)

Protocol – The protocol which generated this route information. (Options: Local, Static)

Interface

To display the routing table:

1. Click IP, Routing, Routing Table.

FIGURE 340

Displaying the Routing Table

Advertising