Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 378)

328 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Address Table Commands
17
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use the no form to remove an
address.
Syntax
mac-address-table static mac-address interface interface vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
mac-address - MAC address.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan-id - VLAN ID (Range: 1-4093)
action -
delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a specific VLAN. Use
this command to add static addresses to the MAC Address Table. Static addresses have the
following characteristics:
• Static addresses will not be removed from the address table when a given interface link is
down.
• Static addresses are bound to the assigned interface and will not be moved. When a static
address is seen on another interface, the address will be ignored and will not be written to the
address table.
• A static address cannot be learned on another port until the address is removed with the no
form of this command.
Example
Console(config)#mac-address-table static 00-e0-29-94-34-de interface ethernet 1/1
vlan 1 delete-on-reset
Console(config)#