Configuring local snmpv3 users, Figure 257 s – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 990
940
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Simple Network Management Protocol
42
FIGURE 257
Showing Community Access Strings
Configuring Local SNMPv3 Users
Use the Administration > SNMP (Configure User - Add SNMPv3 Local User) page to authorize
management access for SNMPv3 clients, or to identify the source of SNMPv3 trap messages sent
from the local switch. Each SNMPv3 user is defined by a unique name. Users must be configured
with a specific security level and assigned to a group. The SNMPv3 group restricts users to a
specific read, write, and notify view.
CLI References
•
Parameters
These parameters are displayed:
•
User Name – The name of user connecting to the SNMP agent.
(Range: 1-32 characters)
•
Group Name – The name of the SNMP group to which the user is assigned. (Range: 1-32
characters)
•
Security Model – The user security model; SNMP v1, v2c or v3.
•
Security Level – The following security levels are only used for the groups assigned to the
SNMP security model:
•
noAuthNoPriv – There is no authentication or encryption used in SNMP communications.
(This is the default security level.)
•
AuthNoPriv – SNMP communications use authentication, but the data is not encrypted.
•
AuthPriv – SNMP communications use both authentication and encryption.
•
Authentication Protocol – The method used for user authentication.
(Options: MD5, SHA; Default: MD5)
•
Authentication Password – A minimum of eight plain text characters is required.
•
Privacy Protocol – The encryption algorithm use for data privacy:
•
AES128 - Uses SNMPv3 with privacy with AES128 encryption.
•
AES192 - Uses SNMPv3 with privacy with AES192 encryption.
•
AES256 - Uses SNMPv3 with privacy with AES256 encryption.
•
DES56 - Uses SNMPv3 with privacy with DES56 encryption.
•
Privacy Password – A minimum of eight plain text characters is required.