Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 236)

186 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
802.1X Port Authentication
9
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout held-period 120
Console(config-if)#
dot1x timeout start-period
This command sets the time that a supplicant port waits before resending an EAPOL start frame to
the authenticator. Use the no form to restore the default setting.
Syntax
dot1x timeout start-period seconds
no dot1x timeout start-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout start-period 60
Console(config-if)#
show dot1x
This command shows general port authentication related settings on the switch or a specific
interface.
Syntax
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)