Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1130)

1080 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Filtering and Throttling IGMP Groups
46
Parameters
These parameters are displayed:
• Interface – Port or trunk identifier.
An IGMP profile or throttling setting can be applied to a port or trunk. When ports are
configured as trunk members, the trunk uses the settings applied to the first port member in
the trunk.
• Profile ID – Selects an existing profile to assign to an interface.
• Max Multicast Groups – Sets the maximum number of multicast groups an interface can join at
the same time. (Range: 1-1023; Default: 1023)
• Current Multicast Groups – Displays the current multicast groups the interface has joined.
• Throttling Action Mode – Sets the action to take when the maximum number of multicast
groups for the interface has been exceeded. (Default: Deny)
• Deny - The new multicast group join report is dropped.
• Replace - The new multicast group replaces an existing group.
• Throttling Status – Indicates if the throttling action has been implemented on the interface.
(Options: True or False)
Interface
To configure IGMP filtering or throttling for a port or trunk:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Interface from the Step list.
3. Select a profile to assign to an interface, then set the maximum number of allowed multicast
groups and the throttling response.
4. Click Apply.
FIGURE 371 Configuring IGMP Filtering and Throttling Interface Settings