Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 239)

Brocade 6910 Ethernet Access Switch Configuration Guide 189
53-1002581-01
Management IP Filter
9
Authenticator PAE State Machine
State : Authenticated
Reauth Count : 0
Current Identifier : 3
Backend State Machine
State : Idle
Request Count : 0
Identifier(Server) : 2
Reauthentication State Machine
State : Initialize
Console#
Management IP Filter
This section describes commands used to configure IP management access to the switch.
management
This command specifies the client IP addresses that are allowed management access to the switch
through various protocols. Use the no form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client | telnet-client} start-address
[end-address]
all-client - Adds IP address(es) to all groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a range.
end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
TABLE 46 Management IP Filter Commands
Command Function Mode
management Configures IP addresses that are allowed management access GC
show management Displays the switch to be monitored or configured from a browser PE