Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 132)

82 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Line
5
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
timeout login response
This command sets the interval that the system waits for a user to log into the CLI. Use the no form
to restore the default setting.
Syntax
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 10 - 300 seconds)
Default Setting
300 seconds
Command Mode
Line Configuration
Command Usage
• If a login attempt is not detected within the timeout interval, the connection is terminated for
the session.
• This command applies to both the local console and Telnet connections.
• The timeout for Telnet cannot be disabled.
• Using the command without specifying a timeout restores the default setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#