Meg-level, Mep-monitor, Meg-level mep-monitor – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 415
Brocade 6910 Ethernet Access Switch Configuration Guide
365
53-1002581-01
ERPS Commands
19
meg-level
This command sets the Maintenance Entity Group level for a ring. Use the no form to restore the
default setting.
Syntax
meg-level level
level - The maintenance entity group (MEG) level which provides a communication channel
for ring automatic protection switching (R-APS) information. (Range: 0-7)
Default Setting
0
Command Mode
ERPS Configuration
Command Usage
•
This parameter is used to ensure that received R-APS PDUs are directed for this ring. A unique
level should be configured for each local ring if there are many R-APS PDUs passing through
this switch.
•
If CFM continuity check messages are used to monitor the link status of an ERPS ring node as
specified by the
command, then the MEG level set by the meg-level command
must match the authorized maintenance level of the CFM domain to which the specified MEP
belongs.
Example
Console(config-erps)#meg-level 0
Console(config-erps)#
Related Commands
mep-monitor
This command specifies the CFM MEPs used to monitor the link on a ring node. Use the no form to
restore the default setting.
Syntax
mep-monitor {east | west} mep mpid
east - Connects to next ring node to the east.
west - Connects to next ring node to the west.
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None