Figure 189 downl – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 899
Brocade 6910 Ethernet Access Switch Configuration Guide
849
53-1002581-01
Configuring HTTPS
41
NOTE
The switch must be reset for the new certificate to be activated. To reset the switch, see
on page 671 or type “reload” at the command prompt:
Console
#
reload
CLI References
•
Parameters
These parameters are displayed:
•
TFTP Server IP Address – IP address of TFTP server which contains the certificate file.
•
Certificate Source File Name – Name of certificate file stored on the TFTP server.
•
Private Key Source File Name – Name of private key file stored on the TFTP server.
•
Private Password – Password stored in the private key file. This password is used to verify
authorization for certificate use, and is verified when downloading the certificate to the switch.
•
Confirm Password – Re-type the string entered in the previous field to ensure no errors were
made. The switch will not download the certificate if these two fields do not match.
Interface
To replace the default secure-site certificate:
1. Click Security, HTTPS.
2. Select Copy Certificate from the Step list.
3. Fill in the TFTP server, certificate and private key file name, and private password.
4. Click Apply.
FIGURE 189
Downloading the Secure-Site Certificate