Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 777)

Brocade 6910 Ethernet Access Switch Configuration Guide 727
53-1002581-01
IEEE 802.1Q VLANs
34
FIGURE 79 Configuring Static VLAN Members by Interface
To configure static members by interface range:
1. Click VLAN, Static.
2. Select Edit Member by Interface Range from the Action list.
3. Set the Interface type to display as Port or Trunk.
4. Enter an interface range.
5. Modify the VLAN parameters as required. Remember that the PVID, acceptable frame type,
and ingress filtering parameters for each interface within the specified range must be
configured on either the Edit Member by VLAN or Edit Member by Interface page.
6. Click Apply.
FIGURE 80 Configuring Static VLAN Members by Interface Range