8 code table for fistandardfl series, Code table for “standard” series, Configuration – Lenze 8200 Frequency inverters User Manual
Page 214: 8 code table for “standard” series
Configuration
8200SHB0199
7-77
7.8
Code table for “Standard” series
How to read the code table:
Column
Abbreviation
Meaning
Code
C013
Code C013
-
The parameter of the code can be different in PAR1 and PAR2.
-
The parameter value is accepted immediately (ONLINE).
C009*
-
The parameter value of the code is always the same in PAR1 and PAR2, but is
always displayed in PAR1.
C001
¤
-
The parameter value of the code will be accepted after pressing SH+ PRG.
[C002]
-
The parameter value of the code will be accepted after pressing SH+ PRG but
only, if the controller is inhibited.
C010
-
Parameter value of the code will only be displayed in [Hz], if C500 = 2000 and
C501 = 10 (factory setting). See chapter 7.6.3.
Name
820X
Name of the code.
Unit-specific setting possibilities (here for 820X).
Without unit designation the code is valid for all unit types.
Lenze
Factory setting of the code
*
The column ”Important” contains further information
Choice
1
{1 %}
99 Min. value
{Steps/Unit}
Max. value
Info
-
Meaning of the code
IMPORTANT
-
Additional, important explanation of the code
Code
Name
Possible settings
IMPORTANT
Code
Name
Lenze
Choice
Info
IMPORTANT
C001
¤ Operating mode
-0-
-0-
Setpoint selection via term. 8
Control via terminals
Parameter setting via 8201BB
-1-
Setpoint selection via 8201BB or
LECOM
Control via terminals
Parameter setting via 8201BB
-2-
Setpoint selection via term. 8
Control via terminals
Parameter setting via LECOM
-3-
Setpoint selection via LECOM
Control via LECOM
Parameter setting via LECOM
Page 7-9,
7-42
[C002]* Parameter set
-0-
Function executed
-1-
Overwrite PAR1 with factory setting
-2-
Overwrite PAR2 with factory setting
-3-
Overwrite PAR1 and PAR2 with the
data of the operating module
-4-
Overwrite PAR1 with the data of the
operating module
-5-
Overwrite PAR2 with the data of the
operating module
-6-
Transmit PAR1 and PAR2 to the
operating module
Page 7-10
C004
¤ Switch-on display
-0-
-0-
Field frequency f
d
-1-
Unit load
-2-
Motor current
Page 7-62
Show/Hide Bookmarks