Lenze 8200 Frequency inverters - Manual (Page 302)

Glossary
8200SHB0199 17-1
17 Glossary
Term Meaning
AIF Automation interface (X1)
CAN Controller Area Network
CE Communauté Européenne (English: European Community)
Code For entry and display (access) of parameter values
Variable addressing according to the format ”code/subcode” (Cxxxx/xx)
All variables can be addressed via the code digits.
Ctrl. enable Controller enable
Ctrl. inhibit Controller inhibit ( = Controller enable)
Fieldbus For data exchange between superimposed control and positioning control, e.g. INTERBUS or PROFIBUS
FPDA Freely programmable digital output
FPDE Freely programmable digital input
GDC Global Drive Control (PC-program (Windows) for Lenze controllers)
RFG Ramp generator
INTERBUS Industrial communication standard to DIN E19258
JOG Fixed speed or input for fixed speed
Target position The target which is to be approached by means of a defined traversing profile
LECOM Lenze Communication
LEMOC2 PC-program (DOS) for Lenze controllers
LU Undervoltage
Master Masters are host systems, e.g. PLC or PC.
OU Overvoltage
PC Personal Computer
P
DC
This power can be additionally obtained from the DC bus when operating a matching motor.
PM Permanent magnet
PROFIBUS Communication standard DIN 19245, consisting of part 1, part 2 and part 3
Process data For instance, setpoints and actual values of controllers which must be exchanged within a minimum of time
Process data are usually small amounts of data which are to be transmitted cyclically.
For PROFIBUS, these data are transmitted in the logic process data channel.
QSP Quick stop
Slave Bus device which may only send after the request of the master. Controllers are slaves.
PLC Programmable logic controller
Show/Hide Bookmarks