Yaskawa AC Drive P1000 Bypass Technical Manual - Manual (Page 78)

Step Display/Result
5. Save the setting by pressing
. Entry Accepted
6. The display automatically returns to the display shown in Step 3.
DRV-OFF
T1- 01 = 3 *3*
V/f Engy Sav Tun
Tuning Mode Sel
DATA ESC
n Enter Data from the Motor Nameplate
After selecting the type of Auto-Tuning, enter the data required from the motor nameplate.
Note: These instructions continue from Step 6 in “Selecting the Type of Auto-Tuning”.
Step Display/Result
1. Press
to access the motor output power parameter T1-02.
DRV-OFF
T1- 02 = 0.75kW
(0.00 - 650.00)
“0.75kW”
Mtr Rated Power
DATA ESC
2. Press
to view the default setting.
DRV-OFF
T1-02= 0 00.75kW
(0.00 - 650.00)
“0.75kW”
Mtr Rated Power
3. Press
F1
left ,
F2
right , , , and to enter the motor power nameplate data in
kW.
DRV-OFF
T1-02= 000.4 0 kW
(0.00 - 650.00)
“0.75kW”
Mtr Rated Power
4. Press
to save the setting. Entry Accepted
5. The display automatically returns to the display in Step 1.
DRV-OFF
T1- 02 = 0.40kW
(0.00 - 650.00)
“0.75kW”
Mtr Rated Power
DATA ESC
6.
Repeat Steps 1 through 5 to set the following parameters:
• T1-03, Motor Rated Voltage
• T1-04, Motor Rated Current
• T1-05, Motor Base Frequency
• T1-06, Number of Motor Poles
• T1-07, Motor Base Frequency
DRV-OFF
T1- 03 = 200.0VAC
(0.00 - 255.00)
“200.0VAC”
Rated Voltage
DATA ESC
DRV-OFF
T1- 10 = X.XXHz
(0.00 - 20.00)
“X.XX Hz”
Mtr Rated Slip
DATA ESC
Note: 1. For details on each setting, Refer to T1: Parameter Settings during Induction Motor Auto-Tuning on page 79 .
2. To execute Stationary Auto-Tuning for line-to-line resistance only, set parameters T1-02 and T1-04.
4.7 Auto-Tuning
78 YASKAWA SIEP YAIP1B 01A YASKAWA AC Drive – P1000 Bypass Technical Manual