MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 586)

14 - 4
MELSEC-Q
14 DEDICATED INSTRUCTIONS
[Control data]
Device Item Setting data Setting range
Setting side
( 1)
(S)+0 System area – – –
(S)+1 Complete status
The state at the time of completion is stored.
• 0 : Normal completion
• Other than 0 : Abnormal completion (error code)( 2)
– System
(S)+2
Signal received from
servo amplifier
The following signal states taken in from the servo
amplifier to the input module are written.
• b0: ABS data bit 0
• b1: ABS data bit 1
• b2: Transmission data READY flag
b0: 0/1
b1: 0/1
b2: 0/1
User
(S)+3
Signal transmitted to
servo amplifier
The ON/OFF states of the following data which are
calculated using the dedicated instructions by the
"signals received from the servo amplifier" and output to
the servo amplifier are stored.
• b0: Servo amplifier ON
• b1: ABS transfer mode
• b2: ABS request flag
– System
(S)+4 Status
Status of communication with servo amplifier
• 0 : Communication completed
(Set by user at communication start)
• Other than 0 : During communication (System stores)
0 User/system
(S)+5 to
(S)+7
System area – – –
1: The data on the setting side is as follows.
• User : Data before the execution of dedicated instructions is stored by user.
• System: Data after the execution of dedicated instruction is stored by PLC CPU.
2: Refer to Section 15.2 for error codes at abnormal completion.
[Functions]
(1) The positioning data is read from the servo amplifier capable of processing the
absolute positions of the axes to be set (See below), and the values converted with
respect to a unit are stored in " Md.20 current feed value" and " Md.21 machine
feed value" area of the QD75.
• ABRST1: Axis 1
• ABRST2: Axis 2
• ABRST3: Axis 3
• ABRST4: Axis 4
For absolute position detection system, carry out the absolute position restoration
operation each time the power is turned ON or PLC CPU is reset.
(S)+0
(S)+1
(S)+2
(S)+3
(S)+4
(S)+5
(S)+7
Control data
PLC CPU
Current
feed value Input module
Output module
Servo amplifier
QD75
Current value data
ABRST
Machine
feed value