MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 756)

Index - 6
[K]
kPPS (Explanation of positioning terms)
.......................................................... Appendix-79
[L]
Last executed positioning data No. ( Md.46 )
..................................................................... 5-108
LED display functions.................................. 15-36
LEND ........................................................... 9-105
Limit switch (Explanation of positioning terms)
.......................................................... Appendix-79
Linear interpolation (Explanation of positioning
terms)................................................ Appendix-80
List of block start data ................................... 5-74
List of condition data ..................................... 5-80
List of configuration devices............................ 2-4
List of control data ....................................... 5-110
List of dedicated instructions......................... 14-2
List of devices used......................................... 6-5
List of errors................................................... 15-6
List of functions................................................ 3-4
List of input/output signal details................... 3-20
List of input/output signals............................. 3-14
List of monitor data........................................ 5-86
List of parameters.......................................... 5-20
List of positioning data .................................. 5-58
List of warnings............................................ 15-30
Load inertia ratio (Explanation of positioning
terms)................................................ Appendix-80
LOOP........................................................... 9-104
Lower limit...................................................... 3-20
Low-inertia motor (Explanation of positioning
terms)................................................ Appendix-80
[M]
M code (Condition data No., No. of LOOP to
LEND repetitions) ( Da.10 ) ......................... 5-70
M code (Explanation of positioning terms)
.......................................................... Appendix-80
M code OFF request ................................... 12-63
M code OFF request ( Cd.7 ) .................... 5-112
M code ON signal.......................................... 3-15
M code ON signal output timing.................. 12-62
M code ON signal output timing ( Pr.18 )... 5-30
M code output function ................................12-62
Machine feed value........................................9-16
Machine feed value ( Md.21 ) .......................5-96
Machine feed value (Explanation of positioning
terms) ............................................... Appendix-80
Machine OPR...................................................8-4
Main functions ..................................................3-6
Major positioning controls................................9-2
Manual control................................................11-2
Manual pulse generator...................................2-4
Manual pulse generator................................ A-13
Manual pulse generator (Explanation of
positioning terms)............................. Appendix-80
Manual pulse generator 1 pulse input
magnification ( Cd.20 ) ...............................5-122
Manual pulse generator enable flag ( Cd.21 )
......................................................................5-122
Manual pulse generator input selection ( Pr.24 )
........................................................................5-36
Manual pulse generator operation ..............11-27
Manual pulse generator operation program
........................................................................6-20
Manual pulse generator operation start time chart
......................................................................11-34
Manual pulse generator operation timing and
processing times ..........................................11-29
Master axis (Explanation of positioning terms)
.......................................................... Appendix-80
Max. connection distance ................................3-3
Max. output pulse.............................................3-3
Mechanism of positioning control....................1-7
Monitor data area.............................................7-3
Movement amount after near-point dog ON
( Md.34 ) ......................................................5-104
Movement amount per pulse ( Pr.2 to Pr.4 )
........................................................................5-20
Movement amount per pulse (Explanation of
positioning terms)............................. Appendix-81
Movement amount per rotation ( Pr.3 ).......5-20
Multi-phase pulse (Explanation of positioning
terms) ............................................... Appendix-81
Multiple axes simultaneous start control .....10-20