Synaccess Networks NP-0801DTM - Manual (Page 100)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 100
Notes
„
The setting is saved in non‐volatile memory and available after a reboot.
GPRS Attach or Detach +CGATT
Execute command attaches the terminal to, or detaches the terminal from, the GPRS service depending on the
parameter <state>.
Read command returns the current GPRS service state.
Test command requests information on the supported GPRS service states.
Syntax
Command Command type
AT+CGATT=[<state>] Execute
AT+CGATT? Read
AT+CGATT=? Test
Parameters and Values
<state> State of GPRS attachment.
0 Detached.
1 Attached.
Notes
„
Reference: 3GPP TS 27.007
Examples
AT+CGATT?
+CGATT: 0
OK
AT+CGATT=?
+CGATT: (0,1)
OK
AT+CGATT=1
OK
GPRS Event Reporting +CGEREP
Set command enables or disables sending of unsolicited result codes +CGEV: XXX from TA to TE in the case of
certain events occurring in the TA or the network. For more information see the section Unsolicited Result Codes.
Read command returns the current <mode> and <bfr> settings, in the format:
+CGEREP: <mode> ,<bfr>
Test command reports the supported range of values for the +CGEREP command parameters.