Synaccess Networks NP-0801DTM - Manual (Page 261)

ENHANCED IP STACK EXTENSIONAT COMMANDS
261 HSPA+ AT Commands Reference Guide
through #GSMCONT.
Format is:
#GDATAVOL: <cidn>,<totn>,<sentn>,<receivedn>[<CR><LF>#GDATAVOL:
<cidm>,<totm>,<sentm>,<receivedm>[…]]
2 Reports the total GPRS data counter, since last reset, for the all the set PDP
contexts (that is, all the PDP context with APN parameter set using +CGDCONT)
and the total GSM data counter for the GSM context, if set through #GSMCONT.
Format is:
#GDATAVOL: <cidn>,<totn>,<sentn>,<receivedn>[<CR><LF>
#GDATAVOL: <cidm>,<totm>,<sentm>,<receivedm>[…]]
Reporting parameters are as follows:
<cidn> PDP context identifier.
0 Specifies the GSM context.
1‐5 Numeric parameter which specifies a particular PDP context definition.
<totn> Number of bytes either received or transmitted in the last GPRS (or GSM) session
for <cidn> PDP context.
<sentn> Number of bytes transmitted in the last GPRS (or GSM) session for <cidn> PDP
context.
<received> <receivedn> ‐ number of bytes received in the last GPRS (or GSM) session for
<cidn> PDP context.
Notes
„
Last GPRS and GSM session counters are not saved in non‐volatile memory so they are lost at power off.
„
Total GPRS and GSM session counters are saved in non‐volatile memory.
ICMP Ping Support #ICMP
Set command enables or disables the ICMP ping support.
Read command returns whether the ICMP ping support is currently enabled or not, in the format:
#ICMP: <mode>
Test command reports the supported range of values for the <mode> parameter.
Syntax
Command Command type
AT#ICMP=<mode> Set
AT#ICMP? Read
AT#ICMP=? Test
Parameters and Values
<mode>
0 Disable ICMP ping support. Default: 0.
1 Enable firewalled ICMP ping support. The module is sending a proper
ECHO_REPLY only to a subset of IP Addresses pinging it. The #FRWL specifies is
subset of IP addresses.
2 Enable free ICMP ping support. The module is sending a proper ECHO_REPLY to
every IP address pinging it.