Synaccess Networks NP-0801DTM - Manual (Page 220)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 220
#SCFG: 4,1,300,90,600,50
#SCFG: 5,1,300,90,600,50
#SCFG: 6,1,300,90,600,50
OK
Socket Configuration Extended #SCFGEXT
Set command sets the socket configuration extended parameters
Read command returns the current socket extended configuration parameters values for all the six sockets, in the
format:
#SCFGEXT:<connId1>, <srMode1>,<dataMode1>,<keepalive1>,
<ListenAutoRsp1>,0<CR><LF>
. . .
#SCFGEXT:<connId6>, <srMode6>,<dataMode6>,<keepalive6>,
<ListenAutoRsp6>,0<CR><LF>
Test command returns the range of supported values for all the subparameters
Syntax
Command Command type
AT#SCFGEXT=<conned>,<srMode>,<recvDataMode>,<keepalive>,
[,<ListenAutoRsp> [,<sendDataMode>]] Set
AT#SCFGEXT? Read
AT#SCFGEXT=? Test
Parameters and Values
<connId> Socket connection identifier.
1‐6
<srMode> SRing unsolicited mode.
0 Normal. Default: 0.
SRING : <connId> where <connId> is the socket connection identifier
1 Data amount.
SRING : <connId>,<recData> where <recData> is the amount of data received on the
socket connection number <connId>
2 Data view.
SRING : <connId>,<recData>,<data> same as before and <data> is data received
displayed following <dataMode> value.
<recvDataMode> Data view mode for received data in command mode(AT#SRECV or <srMode> = 2).
0 Text mode. Default: 0.
1 Hexadecimal mode.
<keepalive> Set the TCP Keepalive value in minutes.
0 Deactivated. Default: 0.