Synaccess Networks NP-0801DTM - Manual (Page 124)

3GPP TS 27.005 AT COMMANDS FOR SMS AND CBS
HSPA+ AT Commands Reference Guide 124
data coding schemes. Default: empty string (“”).
Note: The current settings are stored through +CSAS.
Notes
„
Reference: GSM 27.005, 3GPP TS 23.041, 3GPP TS 23.038.
Examples
AT+CSCB?
+CSCB: 1,"",""
OK (all CBMs are accepted, none is rejected)
AT+CSCB=0,"0,1,300-315,450","0-3"
OK
Save Settings +CSAS
Execute command saves settings—made by the +CSCA, +CSMP and +CSCB commands—in local, non‐volatile
memory.
Test command returns the possible range of values for the parameter <profile>.
Syntax
Command Command type
AT+CSAS[=<profile>] Execute
AT+CSAS=? Test
Parameters and Values
<profile>
0 Settings saved to non‐volatile memory. Default: 0.
1‐n SIM profile number. The value of n depends on the SIM. Maximum is 3.
Notes
„
The SIM may not support certain settings, therefore they are always saved to non‐volatile memory, regardless
the value of <profile>.
„
If parameter is omitted the settings are saved in non‐volatile memory.
„
+CSCB <mids> (Message Identifiers) parameter can be saved to SIM only if the “Cell broadcast message
identifier selection” file is present on the SIM itself. This file, if present, has storage for only a single set of data.
Therefore, it is not possible to save different <mids> in different SIM profiles. The <mids> value, once changed
and saved, is the same for all SIM profiles.
„
Reference: GSM 27.005
Restore Settings +CRES
Execute command restores message service settings saved by +CSAS command from either non‐volatile memory
or SIM.
Test command returns the possible range of values for the parameter <profile>.