Synaccess Networks NP-0801DTM - Manual (Page 294)

GPS AT COMMANDS SET
HSPA+ AT Commands Reference Guide 294
Save GPS Parameters Configuration $GPSSAV
Execute command stores the current GPS parameters in the non‐volatile memory of the device.
Test command returns the OK result code.
Syntax
Command Command type
AT$GPSSAV Execute
AT$GPSSAV=? Test
Notes
„
To use the new configuration, restart the module.
Examples
AT$GPSSAV
OK
Restore to Default GPS Parameters $GPSRST
Execute command resets the GPS parameters to default configuration and stores them in the non‐volatile memory
of the device.
Test command returns the OK result code.
Syntax
Command Command type
AT$GPSRST Execute
AT$GPSRST=? Test
Notes
„
To use the new configuration, restart the module.
Examples
AT$GPSRST
OK
GPS NVRAM Parameters Delete $GPSNVRAM
Execute command deletes the GPS information stored in NVRAM.
Read command reports the current value of the <bitfield> parameter, in the format:
$GPSNVRAM: <bitfield>
Test command returns the supported range of values for <bitfield>,<action>.