Synaccess Networks NP-0801DTM - Manual (Page 54)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 54
Parameters and Values
<mode>
0 Disable network registration unsolicited result code. Default: 0.
1 Enable network registration unsolicited result code.
If <mode>=1, network registration result code reports:
+CREG: <stat>
where
<stat>
0 ‐ not registered, ME is not currently searching a new operator to register to
1 ‐ registered, home network
2 ‐ not registered, but ME is currently searching a new operator to register to
3 ‐ registration denied
4 ‐unknown
5 ‐ registered, roaming
2 Enable network registration unsolicited result code with network Cell identification
data.
If
< mode> =2, network registration result code reports:
+CREG: <stat>[,<Lac>,<Ci>[, <AcT> ]]
where:
<Lac> ‐ Local Area Code for the currently registered on cell
<Ci> ‐ Cell Id for the currently registered on cell
<AcT> : access technology of the registered network:
0 GSM
2 UTRAN
Note: <Lac>, and <Ci> and
<AcT> are reported only if <mode> =2 and the mobile is
registered on some network cell
Notes
„
Reference: 3GPP TS 27.007.
Examples
AT
OK
at+creg?
+CREG: 0,2
OK
The MODULE is in network searching state.
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK