Synaccess Networks NP-0801DTM - Manual (Page 97)

3GPP TS 27.007 AT COMMANDS
97 HSPA+ AT Commands Reference Guide
Available AT Commands +CLAC
Execute command causes the mobile equipment to return the AT commands that the user can use, in the
following format:
<AT cmd1>[<CR><LF><AT cmd2>[…]]
where:
<AT cmdn> ‐ defines the AT command including the prefix AT
Test command returns the OK result code
Syntax
Command Command type
AT+CLAC Execute
AT+CLAC=? Test
Notes
„
Reference: 3GPP TS 27.007.
Mobile Equipment Errors
Report Mobile Equipment Error +CMEE
Set command enables or disables the report of result code:
+CME ERROR: <err>
as an indication of an error relating to the +Cxxx commands issued.
When enabled, device related errors cause the +CME ERROR: <err> final result code instead of the default ERROR
final result code. ERROR is always returned when the error message is related to syntax, invalid parameters, or
DTE function.
Read command returns the current value of subparameter <n>:
+CMEE: <n>
Test command returns the range of values for subparameter <n>
Syntax
Command Command type
AT+CMEE=[<n>] Set
AT+CMEE? Read
AT+CMEE=? Test