Synaccess Networks NP-0801DTM - Manual (Page 89)

3GPP TS 27.007 AT COMMANDS
89 HSPA+ AT Commands Reference Guide
Postpone Alarm +CAPD
Set command postpones or dismisses a currently active alarm.
Test command reports the supported range of values for <sec>.
Syntax
Command Command type
AT+CAPD=[<sec>] Set
AT+CAPD=? Test
Parameters and Values
<sec> Integer type value indicating the number of seconds to postpone the alarm.
Maximum is 60 seconds. Default: 0. When 0, the alarm is dismissed.
Setting Date Format +CSDF
This command sets the date format of the date information presented to the user, which is specified by use of the
<mode> parameter. The <mode> affects the date format on the phone display and does not affect the date format
of the AT command serial interface, so it is not used.
The command also sets the date format of the TE‐TA interface, which is specified by use of the <auxmode>
parameter—that is, the <auxmode> affects the <time> of AT+CCLK and AT+CALA. If the parameters are omitted
then this sets the default value of <mode>.
Read command reports the currently selected <mode> and <auxmode> in the format:
+CSDF: <mode>,<auxmode>
Test command reports the supported range of values for <mode> and <auxmode>.
Syntax
Command Command type
AT+CSDF=[<mode>[,<auxmode>]] Set
AT+CSDF? Read
AT+CSDF=? Test
Parameters and Values
<mode>
1 DD‐MMM‐YYYY. Default: 1.
2 DD‐MM‐YY
3 MM/DD/YY
4 DD/MM/YY
5 DD.MM.YY
6 YYMMDD
7 YY‐MM‐DD
<auxmode>
1 yy/MM/dd. Default: 1.
2 yyyy/MM/dd