Synaccess Networks NP-0801DTM - Manual (Page 203)

CUSTOM AT COMMANDS
203 HSPA+ AT Commands Reference Guide
Test command returns the supported values for the TCPATRUND parameters.
Syntax
Command Command type
AT#TCPATRUND=<mod> Set
AT#TCPATRUND? Read
AT#TCPATRUND =? Test
Parameters and Values
<mod>
0 Service disabled.
1 Service enabled.
Notes
„
If SMSATRUN is active on the same instance (see AT#TCPATRUNCFG) the command returns ERROR.
„
When the service is active it is on a specific AT instance (see AT#TCPATRUNCFG), that instance cannot be used
for any other scope. For example if the multiplexer request to establish the instance, the request is rejected.
„
The current setting are stored in non‐volatile memory
„
To start automatically the service when the module is powered‐on, the automatic PDP context activation has to
be set (see AT#SGACTCFG command).
„
If the connection closes or when the module reboots, if service is enabled and context is active, the module tries
to reconnect for the number of attempts specified in AT#TCPATRUNCFG. The delay between one attempt and
the other is specified in AT#TCPATRUNCFG
Closing TCP Run AT Socket #TCPATRUNCLOSE
Closes the socket used by TCP AT RUN service.
Note: TCP AT RUN status is still enabled after this command, so the service re‐starts automatically.
Test command returns OK.
Syntax
Command Command type
AT#TCPATRUNCLOSE
AT#TCPATRUNCLOSE =? Test
TCP Run AT Command Sequence #TCPATCMDSEQ
Set command enable/disable, for TCP Run AT service, a feature that allows giving more than one AT command
without waiting for responses.
It does not work with commands that use the prompt '>' to receive the message body text (for example
“at+cmgs”)
Read command returns the current settings of parameters in the format:
#TCPATCMDSEQ: <mod>
Test command returns the supported values for the TCPATCMDSEQ parameters.