Synaccess Networks NP-0801DTM - Manual (Page 279)

SIM TOOLKIT COMMANDS
279 HSPA+ AT Commands Reference Guide
if <cmdType>=32 (PLAY TONE)
an unsolicited notification is sent if allowed by SIM (see GSM 11.14):
#STN: <cmdType>[,<text>]
where:
<text> ‐ (optional) text to be displayed to user.
In these cases neither #STGI nor #STSR commands are required:
•
AT#STGI is accepted anyway.
• AT#STSR=<cmdType>,0 answers OK but does nothing.
In case of SEND SHORT MESSAGE (<cmdType>=19) command if sending to
network fails an unsolicited notification is sent.
#STN: 119
if <cmdType>=33 (DISPLAY TEXT)
an unsolicited notification is sent if allowed by SIM (see GSM 11.14):
#STN: <cmdType>[,<cmdDetails>[,<text>]
where:
<cmdDetails> ‐ unsigned Integer used as a bit field.
0‐255 ‐ used as a bit field:
bit 1:
0 ‐ normal priority.
1 ‐ high priority.
bits 2 to 7: reserved for future use.
bit 8:
0 ‐ clear message after a delay.
1 ‐ wait for user to clear message.
<text> ‐ (optional) text to be displayed to user.
In this case:
1.
if <cmdDetails>/bit8 is 0 neither #STGI nor #STSR commands are
required:
•
AT#STGI is accepted anyway.
• AT#STSR=<cmdType>,0 answers OK but does nothing.
2. If <cmdDetails>/bit8 is 1 #STSR command is required.
if <cmdType>=40 (SET UP IDLE MODE TEXT) an unsolicited notification is sent:
#STN: <cmdType>[,<text>]
where:
<text> ‐ (optional) text to be displayed to user.
In these cases neither #STGI nor #STSR commands are required:
•
AT#STGI is accepted anyway.
• AT#STSR=<cmdType>,0 answers OK but does nothing.
if <cmdType>=18 (SEND USSD)
an unsolicited notification is sent to the user:
#STN: <cmdType>[,<text>]
where:
<text> ‐ optional text string sent by SIM.
In this case:
•
AT#STSR=18,20 can be sent to end USSD transaction.
• AT#STGI is accepted anyway.