Synaccess Networks NP-0801DTM - Manual (Page 194)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 194
#LANG: <lan>
Test command reports the supported range of values for parameter <lan>
Syntax
Command Command type
AT#LANG=<lan> Set
AT#LANG? Read
AT#LANG=? Test
Parameters and Values
<lan> Selected language.
“en” English. Default: “en”.
“it” Italian.
Enable RX Diversity and Set DARP #RXDIV
This command enables or disables the RX diversity and sets the DARP.
Read command reports the currently selected <DIV_enable> and <DARP_mode> parameters in the format:
#RXDIV: <DIV_enable>,<DARP_mode>
Test command reports the supported range of values for <DIV_enable> and <DARP_mode>
Syntax
Command Command type
AT#RXDIV=<DIV_enable>[,<DARP_mode>]
AT#RXDIV? Read
AT#RXDIV=? Test
Parameters and Values
<DIV_enable> RX diversity.
0 Disable the RX diversity.
1 Enable RX diversity. Default: 1.
<DARP_mode>
0 DARP not supported.
1 DARP phase 1.
2 DARP phase 2 traffic only.
3 DARP always on. Default: 3.
Notes
„
The values set by command are directly stored in non‐volatile memory and do not depend on the specific CMUX
instance.
Set Encryption Algorithm #ENCALG
This command enables or disables the GSM and/or GPRS encryption algorithms supported by the module.