Synaccess Networks NP-0801DTM - Manual (Page 204)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 204
Syntax
Command Command type
AT#TCPATCMDSEQ=<mod> Set
AT# TCPATCMDSEQ? Read
AT# TCPATCMDSEQ =? Test
Parameters and Values
<mod>
0 Service disabled. Default: 0.
1 Service enabled.
TCP Run AT Service to a Serial Port #TCPATCONSER
Set command sets the TCP Run AT in transparent mode, to have direct access to the serial port specified. Data is
transferred directly, without being elaborated, between the TCP Run AT service and the serial port specified.
If the CMUX protocol is running the command returns ERROR.
Test command returns the supported values for the TCPATCONSER parameters.
Syntax
Command Command type
AT#TCPATCONSER=<port>,<rate> Set
AT#TCPATCONSER =? Test
Parameters and Values
<port>
0‐1 Serial port to connect to.
<rate> Baud rate for data transfer. Allowed values appear under <rate>.
300
1200
2400
4800
9600
19200
38400
57600
115200
Notes
„
You must issue the set command from the TCP AT RUN instance.
„
After you issue the set command, if no error has occurred, then the module issues a “CONNECT” to advise that
the TCP AT RUN instance is in online mode and connected to the port specified.
„
To exit from online mode and close the connection, the escape sequence (+++) must be sent on the TCP AT RUN
instance.