Synaccess Networks NP-0801DTM - Manual (Page 171)

CUSTOM AT COMMANDS
171 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
AT#ACAL=[<mode>] Set
AT#ACAL? Read
AT#ACAL=? Test
Parameters and Values
<mode>
0 Disables the automatic call function. Default: 0.
1 Enables the automatic call function. If enabled (and &D2 is issued), the transition
OFF/ON of DTR causes an automatic call to the first number (position 0) stored in
the internal phonebook.
Notes
„
Type of call depends on the last issue of command +FCLASS.
„
See &Z to write and &N to read the number on module internal phonebook.
Extended Automatic Call #ACALEXT
Set command enables or disables the extended automatic call function.
Read command reports either whether the automatic call function is currently enabled or not, and the last
<index> setting in the format:
#ACALEXT: <mode>,<index>
Test command returns three ranges of values, because the range of available positions in a phonebook depends
on the selected phonebook.
„
<mode>
„
<index> when the internal phonebook is selected.
„
<index> when “SM” is the selected phonebook.
Syntax
Command Command type
AT#ACALEXT=<mode>,<index> Set
AT#ACALEXT? Read
AT#ACALEXT=? Test