Synaccess Networks NP-0801DTM - Manual (Page 207)

CUSTOM AT COMMANDS
207 HSPA+ AT Commands Reference Guide
„
The instance used for the EvMoni service is the same used for the SMS AT RUN service. Therefore, when the
#ENAEVMONICFG sets the <instance> parameter, the change is reflected also in the <instance> parameter of
the #SMSATRUNCFG command, and vice versa.
„
The set command returns ERROR if the command AT#ENAEVMONI? returns 1 as <mod> parameter or the
command AT#SMSATRUN? returns 1 as <mod> parameter
Event Monitoring #EVMONI
Set command enables or disables the single event monitoring, configures the related parameter and associates
the AT command.
Read command returns the current settings for each event in the format:
#EVMONI: <label>,<mode>,<param0>[,<param1>[,<param2>[,<param3>]]]
Where <param0>, <param1>, <param2> and <param3> are defined as before for <param> depending on
<label> value.
Test command returns values supported as a compound value.
Syntax
Command Command type
AT#EVMONI=<label>,<mode>,[,<paramType >,<param>] Set
AT#EVMONI? Read
AT#EVMONI=? Test
Parameters and Values
<label> String parameter—enclosed between double quotes—indicating the event under
monitoring. It can assume the following values:
VBATT Battery voltage monitoring. Not yet implemented.
DTR DTR monitoring. Not yet implemented.
ROAM Roaming monitoring.
CONTDEACT Context deactivation monitoring.
RING Call ringing monitoring.
STARTUP Module start‐up monitoring.
REGISTERED Network registration monitoring.
GPIO1 Monitoring on a selected GPIO in the GPIO range.
GPIO2 Monitoring on a selected GPIO in the GPIO range.
GPIO3 Monitoring on a selected GPIO in the GPIO range.
GPIO4 Monitoring on a selected GPIO in the GPIO range.
GPIO5 Monitoring on a selected GPIO in the GPIO range.
ADCH1 ADC high voltage monitoring.
ADCL1 ADC low voltage monitoring.
DTMF1 Monitoring on user defined DTMF string.
DTMF2 Monitoring on user defined DTMF string.
DTMF3 Monitoring on user defined DTMF string.
DTMF4 Monitoring on user defined DTMF string.