Synaccess Networks NP-0801DTM - Manual (Page 158)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 158
„
Examples
AT#GPIO=3,0,1
OK
AT#GPIO=3,2
#GPIO: 1,0
OK
AT#GPIO=4,1,1
OK
AT#GPIO=5,0,0
OK
AT#GPIO=6,2
#GPIO: 0,1
OK
STAT_LED GPIO Setting #SLED
Set command sets the behavior of the STAT_LED GPIO
Read command returns the STAT_LED GPIO current setting, in the format:
#SLED: <mode>,<on_duration>,<off_duration>
Test command returns the range of available values for <mode>, <on_duration> and <off_duration>.
Syntax
Command Command type
AT#SLED= <mode> [,<on_duration>[,<off_duration>]] Set
AT#SLED? Read
AT#SLED=? Test