Synaccess Networks NP-0801DTM - Manual (Page 32)

HAYES COMPLIANT AT COMMANDS
HSPA+ AT Commands Reference Guide 32
Response Format V
Set command determines the contents of the header and trailer transmitted with result codes and information
responses. It also determines if result codes are transmitted in a numeric form or an alphanumeric form. For more
information about the result codes, refer to “Information Responses And Result Codes”.
Syntax
Command Command type
ATV[<n>] Set
Parameters and Values
<n>
0 Limited headers and trailers and numeric format of result codes
information responses <text><CR><LF>
result codes
<numeric code><CR>
1 Full headers and trailers and verbose format of result codes. Default: 1.
information responses <CR><LF>
<text><CR><LF>
result codes <CR><LF>
<verbose code><CR><LF>
Notes
„
The <text> portion of information responses is not affected by this setting.
„
If parameter is omitted, the command has the same behavior as ATV0.
„
Reference: V.25ter.
Extended Result Codes X
Set command selects the result code messages subset that the modem uses to inform the DTE of command
results.
Syntax
Command Command type
ATX[<n>] Set
Parameters and Values
<n>
0 On entering dial‐mode CONNECT result code is given; OK, CONNECT, RING, NO
CARRIER, ERROR, NO ANSWER result codes are enabled . Dial tone and busy
detection (NO DIALTONE and BUSY result codes) are disabled.
1‐4 On entering dial‐mode CONNECT <text> result code is given; all the other result
codes are enabled. Default: 1.
Notes
„
If parameter is omitted, the command has the same behavior as ATX0.
„
For complete control on CONNECT response message see +DR command.
„
Reference: V.25ter.