Synaccess Networks NP-0801DTM - Manual (Page 297)

GPS AT COMMANDS SET
297 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
$GPSSLSR=
<transport_protocol>[,<pos_mode>[,<client_id>,<clientid_type>
[,<mlc_number>,<mlcnumber_type>[,<interval>[,<service_type_
id> [,<pseudonym_indicator>]]]]]]]
AT$GPSSLSR? Read
AT$GPSSLSR=? Test
Parameters and Values
<transport_protocol>
0 CPlane.
1 SUPL.
2 Invalid
Note: If <pos_mode > is Autonomous the <transport_protocol> is invalid.
<pos_mode>
0 Pure MS Assisted ‐ Location estimate from the network (MS Assisted
mode).
1 MS Based ‐ Assistance Data from the network (MS Based mode).
2 MS Assisted Based ‐ Combination of MS‐A and MS‐B modes, location
estimate computed both at UE and Network.
3 Autonomous – Autonomous GPS mode of operation.
Note: If <pos_mode> is Autonomous set the <transport_protocol> to
invalid.
<client_id> String parameter containing the ID of the LCS‐Client to which the location
estimate is transferred.
Note: <client_id> is mandatory for A‐GPS. The <transport_protocol> is
Cplane.
<clientid_type>
0 MSISDN.
1 Invalid. Default: 1.
Note: <client_id> and <clientid_type> are mandatory for A‐GPS mode.
<mlc_number> String parameter containing the address of the GMLC through which the
location estimate is to be sent to the LCS‐Client.
Note: <mlc_number> is mandatory in case of A‐GPS.
<mlcnumber_type>
0 MSISDN.
1 Invalid. Default: 1.
Note: <mlc_number> and <mlcnumber_type> are mandatory for A‐GPS
mode.
<interval> GPS reporting period in seconds. Is sent unsolicited.
0 ‐ 7200 If 0, then a single shot NMEA Message is provided
Value other than 0 sets the period, in seconds, between each NMEA
sentence.
Note: Use AT$GPSNMUN to enable the Unsolicited NMEA sentences.