Synaccess Networks NP-0801DTM - Manual (Page 47)

3GPP TS 27.007 AT COMMANDS
47 HSPA+ AT Commands Reference Guide
<T2> Response timer for the multiplexer control channel in units of ten milliseconds.
2‐255 Default: 30 (300 ms). Note: T2 must be longer than T1.
<T3> Wake up response timer in seconds.
1‐255 Currently not supported, in case of read command 0 is returned.
<k> Window size, for Advanced operation with Error Recovery options.
1‐7 Currently not supported. For read command, 0 is returned.
Notes
„
All the CMUX protocol parameters are fixed as defined in GSM07.10 and cannot be changed.
„
Reference: 3GPP TS 27.007, 3GPP TS 27.010.
Call Control
Hang Up Call +CHUP
Execute command cancels all active and held calls, as well as multi‐party sessions, if running.
Test command returns the OK result code.
Syntax
Command Command type
AT+CHUP Execute
AT+CHUP=? Test
Notes
„
Reference: 3GPP TS 27.007.
Select Bearer Service Type +CBST
Set command sets the bearer service <name> with data rate <speed>, and the connection element <ce> to be
used when data calls originate. This setting is also used during mobile terminated data call setup, in case of single
numbering scheme calls. See +CSNS.
Read command returns current value of the parameters <speed>, <name> and <ce>.
Test command returns the supported range of values for the parameters.
Syntax
Command Command type
AT+CBST=[<speed>[,<name>[,<ce>]]] Set
AT+CBST? Read
AT+CBST=? Test