Synaccess Networks NP-0801DTM - Manual (Page 307)

AUDIO COMMANDS
307 HSPA+ AT Commands Reference Guide
Test command returns the supported range of values of <mode>.
Syntax
Command Command type
AT#SHSSD=<mode> Set
AT#SHSSD? Read
AT#SHSSD=? Test
Parameters and Values
<mode>
0 Disables the handset sidetone.
1 Enables the handset sidetone. Default: 1.
Notes
„
To save the value of <mode> in non‐volatile memory issue the AT&W command.
Speaker Mute Control #SPKMUT
Set command enables or disables the global muting of the speaker audio line, for every audio output—ring,
incoming sms, voice, network coverage.
Read command reports whether the muting of the speaker audio line during a voice call is enabled or not, in the
format:
#SPKMUT: <n>
Test command reports the supported values for <n>.
Syntax
Command Command type
AT#SPKMUT=<n> Set
AT#SPKMUT? Read
AT#SPKMUT=? Test
Parameters and Values
<n>
0 Mute off, speaker active. Default: 0.
1 Mute on, speaker muted.
Notes
„
Set command mutes/activates both speaker audio paths, internal speaker and external speaker.
Tones Configuration
Signaling Tones Mode #STM
Set command enables or disables the signaling tones output on the audio path.
Read command reports whether the current signaling tones status is enabled or not, in the format: