Synaccess Networks NP-0801DTM - Manual (Page 299)

GPS AT COMMANDS SET
299 HSPA+ AT Commands Reference Guide
Update SLP Address $LCSSLP
Set command allows updating the SLP address and SLP port number.
Test command returns the range of values for parameter <slp_address_type>.
Syntax
Command Command type
AT$LCSSLP=<slp_address_type>[,<slp_address>[,<slp_port_number>]] Set
AT$LCSSLP=? Test
Parameters and Values
<slp_address_type> SLP address type.
0 IPv4.
1 FQDN.
2 IMSI.
<slp_address> SLP address in FQDN format or IPv4 format.
<slp_port_number> SlP Port number.
Integer parameter. Default: 7275.
Notes
„
If <slp_address_type> is 0 or 1, then <slp_address> is a mandatory parameter.
Update Location Information $LCSLUI
Set command allows updating the location information.
Test command returns the range of values for <update_type>.
Syntax
Command Command type
AT$LCSLUI=<update_type> Set
AT$LCSLUI=? Test
Parameters and Values
<update_type> Current access technology.
0 GSM.
1 WCDMA.
Notes
„
To read the current access technology, use AT+COPS?.