Synaccess Networks NP-0801DTM - Manual (Page 49)

3GPP TS 27.007 AT COMMANDS
49 HSPA+ AT Commands Reference Guide
ƒ AT+CBST=75,0,0
„
If <name>=1 then <speed>=0,4,6,7,14,68,70,71,75 is not supported.
„
The following settings are recommended
ƒ AT+CBST=71,0,1 for mobile‐to‐mobile calls
ƒ AT+CBST=7,0,1 for mobile‐to‐fix calls
„
Reference: 3GPP TS 27.007.
Radio Link Protocol +CRLP
Set command sets Radio Link Protocol (RLP) parameters used when non‐transparent data calls originate.
Read command returns the current value of the RLP protocol parameters.
Test command returns supported range of values of the RLP protocol parameters.
Syntax
Command Command type
AT+CRLP=[<iws>[,<mws>[,<T1>[,<N2>[,<ver>]]]]] Set
AT+CRLP? Read
AT+CRLP=? Test
Parameters and Values
<iws> IWF window dimension.
1‐61 Default: 61.
<mws> MS window dimension.
1‐61 Default: 61.
<T1> Acknowledge timer (10 ms units).
39‐255 Default: 48.
<N2> Retransmission attempts.
1‐255 Default: 6.
<ver> Protocol version.
0
Notes
„
Reference: 3GPP TS 27.007.
Service Reporting Control +CR
Set command controls whether the intermediate result code +CR is returned from TA to TE.
Read command returns whether the intermediate result code +CR is enabled, in the format:
+CR: <mode>
Test command returns the supported range of values of parameter <mode>.