Synaccess Networks NP-0801DTM - Manual (Page 305)

AUDIO COMMANDS
305 HSPA+ AT Commands Reference Guide
Audio Commands
Audio Basic Configuration
You can use audio commands for MTPCIE H5 and MTCBA H5/EV3.
Select Ringer Sound #SRS
Set command sets the ringer sound.
Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> Ringing tone number.
1‐max
<status> Ringing status.
0 Selected but not playing.
1 Currently playing.
Test command reports the supported values for <n> and <tout>.
Syntax
Command Command type
AT#SRS=[<n>,<tout>] Set
AT#SRS? Read
AT#SRS=? Test
Parameters and Values
<n> Ringing tone.
0 Current ringing tone.
1‐max Ringing tone number. To determine the maximum, issue the Test command
AT#SRS=?.
<tout> Ringing tone playing timer in units of seconds.
0 Ringer is stopped (if present) and current ringer sound is set.
1‐60 Ringer sound playing for <tout> seconds and, if <n> > 0, ringer sound <n> is set as
default ringer sound.
Notes
„
When the command is issued with <n> > 0 and <tout> > 0, the <n> ringing tone is played for <tout> seconds and
stored as default ringing tone.
„
If command is issued with <n> > 0 and <tout> = 0, the playing of the ringing is stopped (if present) and <n>
ringing tone is set as current.
„
If command is issued with <n> = 0 and <tout> > 0 then the current ringing tone is played for <tout> seconds.
„
If both <n> and <tout> are 0 then the default ringing tone is set as current and ringing is stopped.
„
If all parameters are omitted then the behavior of Set command is the same as Read command