Synaccess Networks NP-0801DTM - Manual (Page 183)

CUSTOM AT COMMANDS
183 HSPA+ AT Commands Reference Guide
Read command reports whether the ENS function is currently enabled or not, in the format:
#ENS: <mode>
Where <mode> represents values as described in the Parameters and Values section.
Test command reports the available range of values for parameter <mode>.
Syntax
Command Command type
AT#ENS=[<mode>] Set
AT#ENS? Read
AT#ENS=? Test
Parameters and Values
<mode>
0 Disable ENS function. Default: 0.
1 Enable ENS function. If AT#ENS=1 is issued, the following values are automatically
set:
At every next power‐up. Band GSM 850 and PCS enabled (AT#BND=3)
Only at next power‐up. Automatic Band Selection enabled (AT#AUTOBND=2) only
if the previous setting was equal to AT#AUTOBND=0
Note: The new setting is available after next power‐up.
Note: If ‘Four Band’ Automatic Band Selection is activated (AT#AUTOBND=2), at
power‐up the value returned by AT#BND? might not be 3 if ENS function is
enabled.
Select Band #BND
Set command selects the current GSM and UMTS bands. This command only works if AT#AUTOBND is set to value
of 0 or 1.
Read command returns the current selected band in the format:
#BND: <band> , <UMTS band>
Test command returns the supported range of values of parameters <band> and < UMTS band>.
Syntax
Command Command type
AT#BND=[<band> [, <UMTS band>]] Set
AT#BND? Read
AT#BND=? Test